banner



How To Repair Lg Model Dlgy1702w

ROLLER ASSEMBLY – Part Number: 4581EL2002H

ROLLER ASSEMBLY

PartSelect #: PS12749664

Manufacturer #: 4581EL2002H

This part is sold individually. The drum support roller is establish in your dryer. It is used to agree the drum in identify in the cabinet while letting the pulsate rotate on the back up rollers. It is recommen...

$33.34

In Stock

Social club within the next four hrs and your function ships today!

Dryer Lint Filter Assembly – Part Number: 5231EL1001C

Dryer Lint Filter Associates

PartSelect #: PS3527575

Manufacturer #: 5231EL1001C

The lint filter sits in your dryer, and collects loose lint when the car is operating. Sometimes the lint filter will get clogged or damaged, and in this case, yous will need to supplant your cur...

$23.11

In Stock

Lodge within the next 4 hrs and your part ships today!

Moisture Sensor – Part Number: 6500EL3001A

Moisture Sensor

PartSelect #: PS3529161

Manufacturer #: 6500EL3001A

The sensor controls the temperature in your dryer and will plow off once your clothes take reached the desired dryness level. If you lot notice that your dryer is not giving off enough heat to dry the clo...

$eighteen.77

In Stock

Social club within the next 4 hrs and your part ships today!

Dryer Thermistor – Part Number: 6323EL2001B

Dryer Thermistor

PartSelect #: PS3529026

Manufacturer #: 6323EL2001B

This dryer thermistor temperature sensor helps monitor and regulate the temperature inside a dryer. This part includes the wire harness. If your dryer overheats, does not produce plenty heat, or takes...

$26.86

In Stock

Order within the adjacent iv hrs and your part ships today!

Dryer Drum Belt – Part Number: 4400EL2001F

Dryer Drum Belt

PartSelect #: PS11705916

Manufacturer #: 4400EL2001F

The chugalug wraps the length of the dryer drum, secured by a tension pulley and then loops around the motor pulley. If you detect that the pulsate is non turning properly or at all while your dryer is in succ...

$17.82

In Stock

Order within the next 4 hrs and your part ships today!

Blower Thermostat – Part Number: 6931EL3002M

Blower Thermostat

PartSelect #: PS8747887

Manufacturer #: 6931EL3002M

The thermostat is a part for your dryer, and it is roughly 1 inch long by roughly i.five inches wide. The purpose of the thermostat is to measure the temperature of the air inside your dryer pulsate. As the...

$28.69

In Stock

Lodge inside the next four hrs and your function ships today!

COVER,GUIDE – Part Number: 3550EL1005C

Encompass,GUIDE

PartSelect #: PS12368455

Manufacturer #: 3550EL1005C

$8.58

In Stock

Gild within the side by side four hrs and your role ships today!

High Limit Thermostat – Part Number: 6931EL3003C

Loftier Limit Thermostat

PartSelect #: PS3530484

Manufacturer #: 6931EL3003C

This part is the replacement high-limit thermostat, or just the thermostat for your dryer. Information technology is approximately 2 inches wide from tip to tip. The heart, rectangular portion of the thermostat is app...

$15.07

In Stock

Guild within the adjacent four hrs and your part ships today!

Gas Igniter – Part Number: 5318EL3001A

Gas Igniter

PartSelect #: PS3527801

Manufacturer #: 5318EL3001A

Comes with bracket and wire harness.

$74.63

In Stock

Order within the next 4 hrs and your part ships today!

Thermostat Assembly – Part Number: 6931EL3004B

Thermostat Assembly

PartSelect #: PS3530486

Manufacturer #: 6931EL3004B

$23.61

In Stock

Order within the adjacent iv hrs and your role ships today!

Nosotros're distressing, but our Q&A experts are temporarily unavailable.
Please bank check dorsum later if y'all nevertheless oasis't plant the answer yous need.

Dryer making a thumping and squealing noise when running

Had to replace front end pulsate support rollers. Removed screws underneath summit in dorsum that held bracket that keeps top in identify. Slid top towards rear and lifted up. Removed 4 screws that hold plastic front end panel in place (inside..2 on each corner) Unplugged front end console electric plugs to remove panel. Opened door..removed 2 screws at bottom of door opening. Removed screws on top of front end panel. Unplugged door switch plug. Removed front console. Removed correct front end roller with nine/16th wrench for nut. Adjustable for back of stud. Lifted upward on pulsate to get roller out. Reversed to install. Left roller a bit harder to get to stud. Removed and installed same as right side. Did not attempt to supersede rear rollers. Have them if needed just very much more than involved to replace.

Parts Used:

  • Full Repair Fourth dimension:

    30 - 60 mins

  • Tools:

    Screw drivers, Wrench (Adjustable), Wrench set

34 of 40 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Screeching during functioning

Establish disassembly video and watched several times. Suspected that one of the pulsate wheels had seized up. Found extreme volume of lint and hair within unit of measurement every bit well as a dryer sheet melted on elevation of heating unit. Forepart left pulsate bike was worn down from lint and hair jamming its motility. Video made it easy, not a actually complicated piece of machinery. Replaced all 4 wheels due to normal wearable on other iii. Wanted to be sure drum evenly balanced on all 4. Parts came chop-chop and were like shooting fish in a barrel to install. My sister and I did this together. Would not recommend doing information technology solitary. Took time to vac and wipe down entire unit. Now it runs so placidity we have to await to see if it is operating. Got a brand new machine out of it, saved a couple of hundred dollars in repair bills, and constitute 11 cents inside the machine. For your own slice of mind, if you have had your dryer for several years, you demand to open information technology upward and clean it out. Its non hard... added note, we are both in our 60'south... so if we tin can do it then tin can you.... Such a feeling of accomplishment, can't purchase that in a shop....

Parts Used:

  • Difficulty Level:

    Really Like shooting fish in a barrel

  • Full Repair Time:

    More than than 2 hours

  • Tools:

    Pliers, Screw drivers

xiv of 14 people found this instruction helpful.

Was this instruction helpful to you lot?

Thank you for voting!

Gas Dryer non getting hot

I noticed the flame would start, then quit later on about 15 seconds. I checked the flame detector, and plant the lenze cracked. I replaced information technology, and it's every bit proficient as golden.

It looked like a hard job to take the drum out to become at the function. But the top was off with 3 screws, the front about 6 I recollect. Then the front end frame, only 4 screws. I think setting the chugalug tentioner was the hardest thing to do.

Washed in 45 minutes, both the chore, and so the next load of laundry.

Parts Used:

  • Terry from Goose Creek, SC

  • Total Repair Time:

    thirty - 60 mins

14 of 21 people found this instruction helpful.

Was this instruction helpful to you?

Thanks for voting!

Source: https://www.partselect.com/Models/DLGY1702W/Manufacturer/73/

Posted by: barringtonshrebadegge.blogspot.com

0 Response to "How To Repair Lg Model Dlgy1702w"

Post a Comment

Iklan Atas Artikel

Iklan Tengah Artikel 1

Iklan Tengah Artikel 2

Iklan Bawah Artikel